|
Tuning/Upgrade of my old Philips CD 650
Player |
Zusammenfassung meines Upgrades:
Austausch der beiden 220 uF Elektrolyt Kondensatoren (2366/2367) durch Nichicon KZ
220 uF 25 V
Austausch
der 47 uF Elektrolyt Kondensatoren (2358/2364/2359/2365) um die OP's
durch
Panasonic FC 100 uF 25 V
berbrcken der drei 47 uF Elektrolyt Kondensatoren (2344/2345/2325) um den TDA1541P D.A.C.
mit Panasonic 47uF 25 V (auf der Rckseite der Printplatte)
PH CD650 - DAC &
1st filter
PH CD650 - PSU &
1st filter
DAC & Filter
Austausch
folgender Elektrolyt Kondensatoren in der Stromversorgung durch Panasonic FC
47uF 25V (2400/2403/2401/2402), 1000uF 35V (2395/2398/2397) und 10.000uF 25V
(2396 - Panasonic TS-HA)
Entfernen
aller Widerstnde (3360/3361/3362/3363/3366/3367) und Transistoren (6319/6320/6321/6322)
zwischen Ausgangs Kondensator (3366/3367
- Nichicon KZ 220 uF) und der Cinch Buchse. Einlten von je eines 10 kOHM
Widerstandes zur Masse (anstelle von
4,7 kOHM) je eines 100 OHM Widerstands vom Kondensator zur Chich Buchse.
Auslten
der beiden NE5532N (6306 & 6307) OP AMP einlten von guten Sockeln, und zwei AD OP275
verwenden.
berbrcken der Panasonic FC 100 uF Kondensatoren (2358/2359/2364/2365) um
die beiden OP AMP's mit
WIMA MKS4 100nF/250V zu Masse Punkt 2362/2363 (star-ground).
berbrcken der beiden 220 uF Kondensatoren (2366/2367 - Nichicon KZ 220 uF 25
V) mit WIMA FKP2 10nF/63V
Entfernen
des internen Kabels zum internen Kopfhrerverstrker.
Ich verwende einen
externen Kopfhrerverstrker
My current WNA MK II Headphone Amp project
und reduziere die Last (Poti 10 kOHM entfallt) fr den DAC Filter OP AMP.
In Audio 09/2006
audio.de - Philips
CD-650 wurde unter "Alte Helden" der
Philips CD-650 beschrieben. Durch meine Modifikationen spielt er sicherlich
in der nchst hheren Klasse!
NEU - "A new Star was born" -
der National
Semiconductor LM4562. Anstelle der AD OP275 verwende ich nun zwei
LM4562.
Die Vernderungen sind nicht spektakulr, aber in den leisen
Hintergrundpassagen ist pltzlich eine Feinzeichnung vorhanden die ich so
noch nie gehrt habe. So z.B. bei Pink Floyd "Final Cut" hrt man die
Hintergrundgerusche (in Q-Sound aufgenommen) trotz Kopfhrer einfach
plastisch. |
|
First Tuning/Upgrade:
Replace the both electrolytic 220 uF capacitors (2366/2367) with Nichicon KZ
220 uF 25 V
Replace the 47 uF (2358/2364/2359/2365) caps around the OP's with
Panasonic FC 100 uF 25 V
Bypass the three 47 uF (2344/2345/2325) caps around the TDA1541P D.A.C.
with Panasonic 47uF 25 V (placed on backside of PCB)
PH CD650 - DAC &
1st filter
PH CD650 - PSU &
1st filter
DAC & Filter |
|
Hearing test (with new cinch cable too) - WOW" its much more better than the
original
headphone output. With Eva
Cassidy "Live At Blues Alley" and some other music all my hairs stand up, I
have never heared this so before. The change of the cable resulted in much
more detail, more air between the musical instruments; trap-brass detail
- it sounds tststs as tszszs before (quick, short beats) - I feel the brass
in front of me!
Some of the special music I
heared too:
Face To Face, Pete Townshend (stereoplay highlights CD 17)
Endless, Charly Antolini (Jeton Reference)
Rock on the Block, Quincy Jones
Blazing Away, Marianne Faithful
Audio Stakkato 3, Audio Hrkurs 4, Audio Hrkurs 5
and many others too. |
|
Second Tuning/Upgrade:
Replace some electrolytic caps
with Panasonic FC
47uF 25V (2400/2403/2401/2402), 1000uF 35V (2395/2398/2397) and 10.000uF 25V
(2396 - Panasonic TS-HA)
Remove all resistors
(3360/3361/3362/3363/3366/3367) and transistors (6319/6320/6321/6322) between the output cap (3366/3367
- Nichicon KZ 220 uF) and
the Cinch female connector. I use only a 10 kOHM resistor to ground (before
4,7 kOHM) and a 100 OHM resistor from cap to connector.
I use a socket for the OP AMP and
now I use two AD OP275.
Bypass
the Panasonic FC 100 uF caps (2358/2359/2364/2365) arround the OP AMP's with
WIMA MKS4 100nF/250V grounded to the ground of the caps 2362/2363 (star-ground).
Bypass
the both electrolytic 220 uF capacitors (2366/2367 - Nichicon KZ 220 uF 25
V) with WIMA FKP2 10nF/63V
Remove
the cable to the internal headphone amp - so remove the internal load of 10
kOHM. |
Hearing test (short with
OPA2134 little more detailed)
with OP275 - the problem I had (before bypass the
2358/2364/2359/2365 with 100nF it
probable oscillate) is solved.
The sound of the OP275 is analytic till to the highest tones (the OPA2134
sounds warmer, more musical).I hope for
feedback from other DIY's  |
Third Tuning/Upgrade:
"A new
star was born" - I replaced the both OP275 with the new
National Semiconductor
LM4562. The variances are "silent" (no spectacle). But I heared
in Pink Floyd "Final Cut" some details in background voices and noises I
never heared so before. This background voices and noises are recorded in
Q-Sound, I heared this with headphones very three-dimensional! I listen to
otherCD's: PF "Whish you where here", Ester Ofarim "Ester", Carl Orff
"Carmina Burana" - O Fortuna, Jos Carreras "Misa Criolla" too with the same
results. |
|
The next step I will do ..... |
|
... hearing .... hearing ..... |
|
This OP AMP's I
have for test:
OP's NE5532N (6306 & 6307) with BB/TI OPA2227P (OPA2228P), OPA2132, OPA2134,
OPA2604 or AD OP275 or ON Semiconductor - SE5532 |
Schema's
move-out from whole page
PH_CD650_AD&filter
PH_CD650_Filter
PH_CD650_headphoneamp
PH_CD650_headphoneamp1
PH_CD650_2nd_filter
whole page
PH CD650 - DAC &
1st filter
PH CD650 - PSU &
1st filter |
|
Next pictures:
Bypass the Panasonic FC 100 uF caps (2358/2359/2364/2365) arround the OP
AMP's with WIMA MKS4 100nF/250V grounded to the ground of the caps 2362/2363
(star-ground) and bypass the both electrolytic 220 uF capacitors (2366/2367
- Nichicon KZ 220 uF 25 V) with WIMA FKP2 10nF/63V
Remove all resistors (3360/3361/3362/3363/3366/3367) and transistors
(6319/6320/6321/6322) between the output cap (3366/3367 - Nichicon KZ 220 uF) and
the Cinch female connector. I use only a 10 kOHM resistor to ground (before
4,7 kOHM) and a 100 OHM resistor from cap to connector.
Please klick on
pictures to enlarge! |
 |
 |
 |
|
Next pictures:
Bypass the three 47 uF (2344/2345/2325) caps around the TDA1541P D.A.C.
with Panasonic 47uF 25 V (placed on backside of PCB)
Please klick on
pictures to enlarge! |
 |
 |
Next pictures:
Some modifications an frontside of PCB and backside of PCB after first step
of tuning.
Please klick on
pictures to enlarge! |
 |
 |
 |
 |
 |
 |
 |
|
|
|
|
Tuning Philips CD 650 - CD Player - Parts |
Panasonic FC electrolytic caps, some WIMA
& EVOX RIFA caps,
Welwyn
resistors RC55Y 0,25W, ALPS
potentiometer, etc.
RS Components |
|
EVOX RIFA PHE 450 caps - (more
interesting parts.... Welwyn
resistors, Rubycon electrolyte caps. etc.)
Distrelec / Schuricht |
|
Black Gate NX, Nichicon KZ electrolyte caps,
Nichicon FG electrolyte caps,
Holco H2/H4 resistors
Michael Percy Audio [Ordering
Information] |
|
parts conneXion
- The authority on hi-fi DIY parts and components |
|
Some parts please see
My current WNA MK II Headphone Amp project
too |
My stock of OP's
NS -
LM6171, LM6172, LM6181
BB / TI - OPA655P,
OPA134, OPA2132,
OPA2227, OPA2228, OPA627, OPA637, OPA2134,
OPA227, OPA228, OPA604, OPA2604, BUF634P,
BUF634T, DRV134
AD - AD711, AD811, AD797,
AD9631, AD9632, AD812, AD823, AD8610, AD797, AD843, AD847, AD8065,
AD OP275
PMI - OP279, OP113, SSM2135
ON Semiconductor -
SE5532, SA5534 / SE5534
Maxim - MAX410, MAX412,
MAX427, MAX437
Look like's as in
BUF634_Schemas
Or as
Per-Anders Sjstrm's - QRV-04 the high performance smd headphone amplifier |
|
DIY Cables |
|
My current CD 650 tuning project |
|
My current WNA MK II Headphone Amp project |
|
DIY Tips |
|
Graham Slee "green Solo" Headphone
Amp |
|
Graham Slee "Green" ERA GOLD
REFLEX Phono Preamp |
|
Tuning Revox Turntable B790 |
|
My preferred Music |
|
Audio Projects -
Main |
|
|
|
Black Gate as a super-E-Caps capacitor |
|
Jelmax H.P.
BlacK Gate - The champion of the circuit cleaning; Black Gate as a
super-E-Caps capacitor
Step 4 - the final circuit
〈Performance〉
It was surprising that all the problems worried about at item (3) were
resolved by replacing all the capacitors with the super-E-Caps.
An amplifier made by Ippinkan, in which all the capacitors are replaced by
the Black Gates, is connected to the output side.
〈Capacitor〉
BGN 16V 33μ2
Non-polarized Black Gate
Super-E-Caps
--------------------------
BGN 50V10μ2
Non-polarized Black Gate
Transcendence electron transfar

What is the "Super-E-Caps"?
--------------------------------------------------------------------------------
A pair of nonpolarized Black Gate electrolytic capacitors are particularly
connected in parallel or in series so that each one of the capacitors
cancels the internal magnetic flux generated by the other, thereby
completely eliminating internal resonance and decreasing total impedance to
absolute zero as the frequency increase.
An ultimate
DC current power source revolution by the ultra electrolytic capacitor Black
Gate - 無題ドキュメント
Source (C) -
Jelmax H.P. TOP page |
|
Farbcode für Widerstände 4 - Berechnung Farbcode Widerstand
Widerstandstabelle Farb Code Ringe - sengpielaudio
Farbcode für Widerstände 12 - Rechner - Widerstand mit 6 Ringen Ringe
Widerstandsbestimmung Farb Farbringe- sengpielaudio |
|
|